Logo

U1092 Engine Trouble Code

Meaning of U1092 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $200-$300 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U1092 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for U1092 code is occuring now you should check U1092 repair processes.
Now don't ask yourself; What should you do with U1092 code ?
The solution is here :

U1092 Possible Solution:

U1092 Engine

Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all.

U1092 Code Meaning :

U 1 0 9 2
OBD-II Diagnostic Network (U) Trouble Code For Engine Fuel And Air Metering Ambient Air Temperature Sensor Circuit Low Crankshaft Position Sensor A Circuit Malfunction Glow Plug/Heater Circuit 'A' Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

U1092 OBD-II Diagnostic Network (U) Trouble Code Description

U1092 engine trouble code is about Glow Plug/Heater Circuit 'A' Malfunction.

Main reason For U1092 Code

The reason of U1092 OBD-II Engine Trouble Code is Ambient Air Temperature Sensor Circuit Low.

U1092 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.